17919 SC-16 Type SC Premium Carbide Burr- Cylinder Shape- Radius EndDouble Cut The most popular burr for ferrous applications. The flutes are ground in both the left and right hand directions, offering better operator control and rapid stock removal in harder materials. The double cut geometry reduces the size of the chips and can be used at slower than normal speeds. Aluma Cut Designed for used on aluminum, non ferrous metals, soft steel, reinforced plastics and other soft materials. The burrs are designed with a

Flange pilots are centered in seal bore

Click here for spec sheets: BUCNPT Spec Sheet

installing the barbed splicer

Operating Temperature 41 to 239 Deg

titanium and certain plastics

Application: Contouring

• Special Hi-Moybdenum tool steel

Reusable fittings provide a simple

• Parabolic flute drills are designed to allow deep hole drilling without frequent drill removal to clear chips

Connect two tubes through a panel or case

This means that a smaller regulator is installed and is used to adjust the R2000 Regulator

Temperature Range: 5°F to 160°F