Element, 40 micron Pro Fuel Filter, Full Stainless Steel, Methanol CompatibleHyper Racing # 88 1681 Full stainless steel, no glue! Any glue, epoxy, weld, or solder will eventually fail, this element is only mechanically assembled so it will last a long, long time. Fits Filter 88 1671 & 88 1701 it can also be used to replace the original epoxy filter element in 88 169 & 88 168. Does not fit the short filter. This filter should be cleaned using our Ultrasonic Cleaner 80 675 or 80 674. Compressed air and solvent will not clean

This cap has a higher pressure rating than our 22-24 pound cap

098-636AM configuration

O-rings (4)

Caliper spacing is 3-1/2" for the Wilwood GP320 4-Piston Brake Caliper (part # 36-101)

Caged Karts

Special made 6AL4V titanium bolt 1/4-20 x 2-1/8" long with flange (no washer needed)

Very little amount of grease is needed for these bearings

The high and low speed valvings are just as important as the stamped 7-2/2 valving

The jackshaft is mounted to the bottom plate by high precision guided slots that keep it square two the engine and chassis while also allowing it to slide front to back to adjust belt tension

Huge stainless steel pleated element with an o-ring seal internally to ensure no dirt slips through

there is no need to purchase another assembly

or CSI twintube shocks